The external seating area
The height of the boat taken from the waterline to the highest fixed point on the boat. (So you won’t hit a low bridge)
Large pieces of metal that are welded to the hull. They “take the hit” leaving the hull protected.
The horizontal steel plates that make up the bottom of a canal boat.
Width of a boat.
The lowest inner part of a ship’s hull. Bilge Water collects in the bilge.
Pump used to empty the bilge
The fore-end, or front of a boat.
This is a steering aid to assist in maneuvering the boat.
A wall within the hull of a boat, they provide support and usually separate different sections to reduce the risk of flooding.
A steel narrow boat with no engine
The hot water tank (like the emersion tank found in houses)
The horizontal edge where 2 steel sheets meet. If a boat is moulded and round shaped it has no chines.
Flat area below the water line above the swim.
The amount of the hull that is below water.
The distance between the waterline and the lowest deck level where water can enter the inside of the boat.
The kitchen on a boat
A fitting to a boat’s electrical system, intended to help prevent galvanic corrosion to the hull.
Glass Reinforced Plastic (Fibreglass)
The top edge of the hull were it joins the cabin side, laterally gun wall but pronounced gunnel as tunnel.
A trapdoor or cover.
A tank for holding toilet waste (also called a black water tank)
The main part of the boat that sits in the water and gives a boat its buoyancy.
A closed system, a slab tank (narrow & baffled) is welded to the inside (normally) of the swim, engine cooling water is then circulated through it. (Does the same job as the radiator on a car). Important Note the engine and cooling system can easily have anti-freeze added to prevent frost damage.
Left-hand side when standing at the stern facing forward (towards the frontend)
Means of emptying the holding tank
Direct Canal water is drawn in via a mud box (normally a watertight container large enough to allow the incoming water time to settle) before being pumped around the engine to cool it then returned to the canal. Important Note the engine and every part cooling system must be completely drained during cold weather to prevent frost damage.
Indirect Canal water is drawn in via a mud box (normally a watertight container large enough to allow the incoming water time to settle) before being pumped though a heat exchanger mounted on the engine it is then returned to the canal. The engines own coolant is also pump through the heat exchanger but is kept separate inside the heat exchanger enabling the engine to be protected with anti-freeze. Important Note The raw water side of the heat exchanger and unprotected parts cooling system must be completely drained during cold weather to prevent frost damage.
The part of the steering system that is in the water.
A steel horizontal bar welded to the base plate (normally in channel form) protruding from the stern to carry the lower end of the rudder post and bearing, it also gives some protection to the propeller.
Right-hand side when standing at the stern facing forward (towards the frontend)
The back
The propeller, propeller shaft, sterntube, sterntube bearing, & stuffing box or packing gland (an adjustable gland to help keep water out of the engine space bilge.
The S shaped steel bar welded to the rudder post to which the tiller bar is fitted (the brass shinny stick with a wooden handle on the end) on a motor boat.
The after (back) underwater part of the hull that goes to a point to allow a cleaner flow of water over the propeller.
(or extension) Fits on the swans neck of a motor boat to give extra leverage. (The brass shinny stick with a wooden handle on the end).
The normally rounded after (back) part of the boat above the water where the steerer stands.
The amount a cabin side slops inwards (to give more bridge clearance).
The line on the boats hull were it floats.
A weedhatch is a device used to gain access to the propeller and shaft
A cranked handle for opening and closing lock paddles.
